Eclipse L4-1795cc 1.8L SOHC (1990)
SERVICE POINTS OF INSTALLATION
17. INSTALLATION OF SELECT CABLE
(1) Move the transaxle shift lever to the neutral position.
NOTE: The select lever will be set to the neutral position when the transaxle shift lever is moved to the neutral position.
(2) Move lever (B) to the neutral position.
(3) Adjust, by using the adjuster, so that the end of the select cable is positioned as shown in the illustration relative to lever (B).
(4) The flange side of the resin bushing at the select cable end should be at the lever (B) end surface.
