Eclipse L4-1795cc 1.8L SOHC (1990)
6.
Using a glassholder (Figure 12), place the glass in the body opening.
7.
Press the glass gently so that no adhesive is squeezed out from under the glass edge (Figure 13).
NOTE:
Do not move the glass after installing onto the body. Place the glass in the original position. Use care not to cover the water drainage groove with
adhesive (in the lower corner of the pinch weld flange).
8.
Press the glass gently so that no adhesive is squeezed out from under the glass edge.
CAUTION:
Do not move or cause the body to flex (Example: Lifting one corner with a jack or driving the vehicle on an uneven surface.) while the adhesive is
hardening, because this movement can damage the bond between the glass and the body.
9.
After bonding the glass to the body apply additional sealant completely around the outside perimeter of the bonded area (Figure 14).
