Recall - ABS Hydraulic Unit Support Cracks in Eclipse L4-1996cc 20L DOHC (1995)
1.
Apply 2"-wide masking tape to the front bumper fascia, along the entire length of the left-side headlight. This will prevent damage to the fascia
while performing the procedure.
2.
Mark the position of the headlight's vertical adjustment bubble. Then, remove the top and rear bolts securing the left-side headlight assembly to the
body.
3.
Insert the flat edge of a plastic or wooden trim stick (approximately 3/4" wide, 1/4" thick, and 8" long) between the lower edge of the headlight
and fascia. Twist the trim stick 1/4 turn to depress the fascia and allow access to the lower headlight mounting bolt.
4.
Using a drive extension and a 10 mm flexible socket (preferably a magnetic socket), remove the lower headlight mounting bolt through the
opening between the fascia and headlight. Remove the trim stick after removing the bolt.
5.
From under the vehicle, disconnect the main headlight wiring harness. Then, with the vehicle on the ground, carefully remove the headlight
assembly, making sure the tab on the lower edge of the headlight does not damage the fascia. Disconnect the turn signal wiring harness from the
headlight assembly.
