mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Electrical - No Start/Hard Start/MIL ON/AC Fan Inop.|Page 5247 > < Electrical - No Start/Hard Start/MIL ON/AC Fan Inop.|Page 5241
Page 1
background image

Condenser Fan: All Technical Service Bulletins
Electrical - No Start/Hard Start/MIL ON/AC Fan Inop.

NO.: TSB-95-54-005

DATE: December, 1995

MODEL: 1995 Eclipse

SUBJECT:    
A-32 CONNECTOR CORROSION

BACKGROUND INFORMATION

On some affected vehicles, corrosion at connector A-32 in the front end harness could cause driveability or electrical problems. Possible symptoms are
no start, hard start, engine stalling, CHECK ENGINE light comes on, and/or A/C condenser fan inoperative. These conditions can be corrected by
eliminating connector A-32 and splicing the harness as described in this bulletin.

VEHICLES AFFECTED

1995 Eclipse non-turbocharged models produced before 5/24/95.

PROCEDURE

1.

Record the pre-set radio stations and radio code if applicable. Then disconnect the battery.

2.

Raise the vehicle.

3.

Remove the left front wheel and wheel well splash-shield.

a.

On automatic transmission models, remove the left side engine room cover (transmission splash shield).

4.

Connector A-32 is mounted against the lower left frame rail. Inspect connector A-32 for corrosion. Disconnect the connector and check the pin
contacts.

a.

If corrosion is found in the connector, proceed with Step 5.

b.

If no corrosion is found, go to Step 8.

Electrical - No Start/Hard Start/MIL ON/AC Fan Inop.|Page 5247 > < Electrical - No Start/Hard Start/MIL ON/AC Fan Inop.|Page 5241