mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Brakes - ABS Lamp ON/Multiple DTC's Set|Page 6276 > < Clutch Switch, Cruise Control|Testing and Inspection
Page 1
background image

ABS Light: All Technical Service Bulletins
Brakes - ABS Lamp ON/Multiple DTC's Set

TSB-96-54-005

June, 1996

1995 Eclipse

ABS LIGHT ON - DTCs 41, 42, 43, 51, & 53

BACKGROUND INFORMATION
On some affected vehicles, corrosion in the front end harness splice near connector A-23, or corrosion in the connector, could cause the ABS warning
light to illuminate and possibly set one or more of the Diagnostic Trouble Codes (DTCs) 41, 42, 43, 51, and/or 53.

These conditions may be corrected by performing the repair procedure in this bulletin.

AFFECTED VEHICLES

1995 Eclipse models equipped with ABS produced before 5/24/95. PROCEDURE

1.

Record the preset radio stations and radio code if applicable. Then disconnect the battery.

2.

Raise the vehicle.

3.

Remove the left front wheel and wheel well splash shield.

4.

Remove the left side engine room cover (transmission splash shield).

5.

Remove the ABS hydraulic unit cover.

5.

Disconnect the A-23 and A-24 connectors from the ABS hydraulic unit.

6.

Inspect connector A-23 for corrosion. Remove any corrosion then proceed with step 7. If cleaning will not sufficiently remove the corrosion, do
not continue with this bulletin procedure. Replace the front end electrical harness and reinstall all parts removed in the previous steps.

Brakes - ABS Lamp ON/Multiple DTC's Set|Page 6276 > < Clutch Switch, Cruise Control|Testing and Inspection