Eclipse L4-1996cc 2.0L DOHC (1995)
6.
The reinforcement bracket kit consists of three parts:
Bracket A (p/n MR217014)
Bracket B (p/n MR217015)
Securing Bolt (p/n MS240126)
7.
Remove and retain the front HU support bolt. This bolt will be used again in Step 11.
8.
Attach bracket A to the HU support using the securing bolt in the Kit. Place this bolt in the lower hole of bracket A. Attach bracket A to the HU
support using the front HU support bolt hole.
9.
Using a 5/16" drill bit, drill a hole through the upper hole of bracket A, and through the HU support.
WARNING:
To avoid damaging the hydraulic lines, do not allow the drill bit to penetrate farther than the HU support.
10.
Loosen the bolt securing bracket A to gain access to the 5/16" hole just drilled into the HU support. De-burr the hole and apply primer. Correctly
re-position bracket A and tighten the securing bolt 14 Nm (10 ft. lbs.).