mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

A/T - Shudder During 1 - 2 Upshift|Page 3643 > < A/T - F4AC1 Limp-In Mode/DTC's Set|Page 3637
Page 1
background image

Technical Service Bulletin # 96-23-023

Date: 961001

A/T - Shudder During 1 - 2 Upshift

NO.: TSB-96-23-023

DATE: October, 1996

MODEL: 1995-96 Eclipse

SUBJECT:
A/T SHUDDER DURING 1-2 UPSHIFT

PURPOSE

Some affected vehicles may experience a shudder condition at 1-2 upshifts during light to moderate throttle. To eliminate this condition, replace the 2-4
clutch plates and discs, and replace the 2-4 accumulator piston if it is the plastic type. Additionally, if there is excessive clutch friction material in the
bottom of the transaxle oil pan, reverse flush and flow check the oil cooler and cooler lines.

AFFECTED VEHICLES

1995-96 Eclipse models equipped with 2.0L non-turbocharged engine with automatic transmission identification codes before XXX-2592-XXXX.

PARTS INFORMATION

Part Number

Description

Quantity Required

M04799860AA

2-4 Clutch disc

4

M04659054

Separator plate

4

M04882934

Seal and gasket set

1

M04864505

A/T filter

1

M04446620

2-4 Aluminum accumulator piston

1

M04446544

Teflon seal ring

2

WARRANTY INFORMATION

Use standard warranty procedures.

Procedure

1.

Using the MUT-II scan tool, confirm that no diagnostic trouble codes (DTCs) are set in the Powertrain Control Module (PCM) or the
Transmission Control Module (TCM). If any DTCs are set, perform the appropriate diagnostic procedures and repairs before proceeding with this
bulletin.

A/T - Shudder During 1 - 2 Upshift|Page 3643 > < A/T - F4AC1 Limp-In Mode/DTC's Set|Page 3637