Eclipse L4-1997cc 2.0L DOHC (1991)
If the plug at the bottom of the auto tensioner protrudes, surround it with a plain washer as illustrated to prevent the plug from being in direct
contact with the vise.
(2) Push in the rod little by little with the vise until the set hole (A) in the rod is aligned with that (B) in the cylinder.
(3) Insert a wire [1.4 mm (0.055 in.) in diameter] into the set holes.
(4) Unclamp the auto tensioner from the vise.
(b) Install the auto tensioner.
Caution: Leave the wire installed in the auto tensioner.
23. Installation of tensioner pulley.
(1) Install the tensioner pulley onto the tensioner arm.
(2) Locate the pinhole in the tensioner pulley shaft to the left of the center bolt. Then, tighten the center bolt finger-tight.
Caution: Leave the wire installed in the auto tensioner.
22. Installation of timing belt.
