mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Idle Air Control Valve Position Sensor <--> [Idle Speed Motor Position Sensor] > < Fuel - System Diagnosis In Tank Filter Clogging|Page 3113
Page 4
background image

3.

Remove the rubber fuel pump vibration dampener to expose the fuel filter retaining clip (or nut). Remove the retaining clip (or nut) and the filter.

4.

Install the new fuel filter onto the fuel pump. If specified in the Service Manual, tighten the fuel filter retaining nut to the proper torque.

5.

Before installing the fuel pump into the tank, observe the condition of the old fuel filter. If the filter was severely clogged, clean the inside of the 
fuel tank thoroughly.

6.

Using a new gasket, install the fuel pump into the fuel tank. Re-assemble all other components.

7.

After installing the fuel pump, run the engine to verify normal operation.

PARTS INFORMATION

For most vehicles, the fuel pump gasket and filter are available from your facing PDC on a stock or daily order. Refer to the latest parts microfiche for
correct part numbers.

WARRANTY INFORMATION

For fuel pump filter replacement:
(Fuel pump filter replacement is a 12/12 coverage item.)

Position Code:

136011

Labor Operation Code:

13601110

Nature Code:

05D

Cause Code

570

Use normal warranty procedures.

Idle Air Control Valve Position Sensor <--> [Idle Speed Motor Position Sensor] > < Fuel - System Diagnosis In Tank Filter Clogging|Page 3113