Eclipse L4-1997cc 2.0L DOHC (1991)
Closed Throttle Position Switch: Testing and Inspection
Idle Position Switch Circuit
To test the Idle Switch, located on the throttle body, proceed as follows.
COMPONENT TEST
1. Disconnect the idle switch / throttle position sensor connector.
2. With the throttle closed, use an ohm meter and check for continuity between terminal 1 and ground.
Continuity
Should exist.
3. Open the throttle approximately 50%, use an ohm meter and check for continuity between terminal 1 and ground.
Continuity
Should not exist.
HARNESS TEST:
1. Disconnect the idle switch / throttle position sensor connector and turn the key to the ON position.
2. Using a Voltmeter, check the Voltage between the harness connector terminal 1 and ground.
Voltage:
4 - 5 Volts.
3. Turn the key OFF, disconnect the negative battery cable and the ECU Connector.
4. Using an ohm meter, check for continuity between ECU harness terminal 14 and ISC harness terminal 1.
Continuity
Should exist.
5. Using an ohm meter, check for continuity between ECU harness terminal 14 and ground.
Continuity
Should not exist.
If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed, road
test the vehicle to confirm that the repair has corrected the problem.
If the same problem reoccurs, it is possible that there is an intermittent failure of the component or the ECU. Check for looseness at all harness
junctions and test for an intermittent failure.
