Eclipse L4-1997cc 2.0L DOHC (1991)
4.
Check the balance of all four wheels, preferably using an on-the-car wheel balancer. If necessary, re-balance the wheels.
5.
Inspect underneath the vehicle for loose or worn suspension parts, leaking struts, or broken exhaust system hangers. Repair or replace these items
as needed.
6.
Check the upper and lower radiator mounting brackets for correct positioning. Refer to Technical Service Bulletin number TSB-93-14-002 for
details.
7.
Inspect the engine roll-stoppers (front and rear), the engine mounting bracket assembly (driver's side of vehicle), and the transaxle mounting
bracket assembly (passenger's side of vehicle) for correct installation. If necessary, correct the installation of these components. Refer to Group 32
of the appropriate service manual for installation instructions.
8.
Test-drive the vehicle at 45-55 mph (smooth road) to determine if the drivetrain vibration has been eliminated. If the vibration is still present, go to
Step 9.
9.
Replace the engine and transaxle mounting bracket assemblies using the part numbers listed. Refer to Group 32 of the appropriate service manual
for replacement instructions.
PARTS INFORMATION
The new engine mounting bracket and transaxle mounting bracket assemblies will be available from your facing PDC beginning the week of May 9,
1994. No orders can be accepted until that time.
One engine and one transaxle mounting bracket assembly are needed per vehicle. Use the part numbers (see illustration).
WARRANTY INFORMATION*
Labor Operation: 32122210 (Engine Mounting Bracket Assembly)
Position Code: 321222
Labor Operation: 32122310 (Transaxle Mounting Bracket Assembly)
Position Code: 321223
Nature Code: 82M
Causal Code: 990
Coverage: 36 months or 50k miles (1990 Models)
Coverage: 60 months or 60k miles (1991-94 Models)
Use standard warranty procedures.
Applies only to replacement of engine and transaxle mounting bracket assemblies. For warranty information on other components, refer to the Labor
Operation Time Schedules (LOTS) manual.
