Eclipse L4-1997cc 2.0L DOHC (1991)
1.
Check the position of the rear runchannel. The runchannel is the hard-plastic track located between the inner and outer door window weatherstrip.
If the runchannel is correctly seated in the rear track, go to PROCEDURE C. If the runchannel is not seated, use a trim stick and rubber mallet to
tap it into correct position.
2.
Retest the window operation. If the window operates normally, reinstall the door panel trim and return the vehicle to the customer. (Refer to the
NOTE under Procedure A.) If the window is still difficult to operate, go to PROCEDURE C.
Procedure C: Adjusting Door To Body & Window To Rear Sash Frame
ADJUSTING DOOR ALIGNMENT TO THE BODY AND DOOR WINDOW ALIGNMENT TO THE REAR SASH FRAME
1.
Observe the door for alignment to the body along its rear edge. If the rear edge of the door is not flush to the body, adjust the door hinges and
striker plate.
2.
Close the window fully and observe its alignment to the rear sash frame. If the window is outboard (sticks out) at the top corner of the sash frame,
