mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Sunroof / Moonroof Cable > < Sunroof - Difficult Sunshade Operation
Page 1
background image

Sun Shade: Customer Interest
Sunroof - Difficult Sunshade Operation

NO.: TSB-97-42A-002
DATE: January, 1997
MODEL: 1995-96 Eclipse

Subject:
SUNROOF SUNSHADE OPERATION

PURPOSE
On some affected vehicles, the sunroof sunshade may become difficult to move or slide out of its track in the sunroof guide assembly. This may be due to
one or both of the sunshade slops becoming deformed. To correct this condition, new, sturdier sunshade stops are now available. The new stops are
installed during production of Eclipse models produced after 3/96.

This bulletin describes how to replace sunshade stops to improve sunshade operation.

AFFECTED VEHICLES
1995-96 Eclipse
Models equipped with sunroof produced before 4/96

PROCEDURE

1.

Open the sunroof to its fully open position.

2.

Remove the sunshade stop from the left and right sunroof guides. The stops are located near the center of each guide.

3.

Inspect each sunshade stop to determine if it is deformed or its ends are rounded. If either stop is deformed or its ends are not straight, replace both
stops, using the part number listed in the PARTS INFORMATION section of this bulletin.

IMPORTANT:

Replace both sunshade stops during repair, even if only one is damaged.

4.

Close the sunroof and verify that the sunshade operates properly.

PARTS INFORMATION

WARRANTY INFORMATION
Sunroof Sunshade Stops (Both Sides)

Nature Code: 99D

Cause Code: 160

Labor Operation No.42369400

Time Allowance: 0.2 hr.

Warranty Coverage: 36 months/36,000 miles.

Special Warranty Information:
Normal warranty procedures apply. 
To be performed on a customer complaint basis only.

Sunroof / Moonroof Cable > < Sunroof - Difficult Sunshade Operation