Eclipse L4-1997cc 2.0L DOHC Turbo 16 Valve (1996)
5. Check to ensure that timing marks on sprockets and front case are in alignment.
6. Press with index finger the center of span on tension side of timing belt "B". The belt must deflect 5-7 mm (0.20-0.28 in.).
I
CRANKSHAFT BOLT TIGHTENING
J
OIL PUMP SPROCKET INSTALLATION
1. Insert a Phillips screwdriver [shank diameter 8 mm (.31 in.)] through the plug hole on the left side of the cylinder block to block the left
counterbalance shaft.
2. Install the oil pump sprocket.
3. Apply a proper amount of engine oil to the bearing surfaces of the nuts.
4. Tighten the nuts to the specified torque.
L AUTO TENSIONER INSTALLATION
1. If the auto tensioner rod is in its fully extended position, reset it as follows.
2. Clamp the auto-tensioner in a vise with soft jaws.
