Eclipse L4-1997cc 2.0L DOHC Turbo 16 Valve (1996)
i.
Ball bearing installation (20).
Apply a coating of the specified fluid to the outside of the ball bearing. Using the special tools, press the oil seal into the valve housing.
Specified fluid: Automatic transmission Fluid "DEXRON II"
j.
Seal ring installation (19).
Because the seal rings expand at the time of installation, tighten after installation by using the special tool to compress the rings, or press down
by hand.
k. Oil seal installation (17).
Using the special tool, press the oil seal into the valve housing.
CAUTION: In order to eliminate a seal malfunction at the valve housing alignment surface, the upper surface of the oil seal should project
outward approximately 1 mm (.04 in.) from the housing edge surface.
l.
End plug installation (14).
1. Apply the specified sealant to the threaded part of the end plug.
Specified sealant: 3M ATD Part No. 8663 or equivalent
2. Secure the threaded portion of the end plug at two places by using a punch.
m. Total pinion torque adjustment.
