Eclipse L4-2.4L SOHC (2004)
NOTE: Also check intermediate connector C-91. If intermediate connectors C-91 is damaged, repair or replace the connector as described in Harness
Connector Inspection.
Q: Is the wiring harness between power window main switch connector E-12 (terminal 9) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the power windows work normally.
STEP 13. Check at power window main switch connector E-12 in order to check the power window relay circuit of the power supply to the
power window main switch.
1. Disconnect power window main switch connector E-12, and measure at the harness side.
2. Turn the ignition switch to "ON" position.
3. Measure the voltage between terminal 6 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Replace the power window main switch. Check that the power windows work normally.
NO: Go to Step 14.
