Eclipse L4-2.4L SOHC (2004)
STEP 6. Check the wiring harness between windshield wiper motor connector A-03 (terminal 2) and front-ECU connector A-11X (terminal 23).
NOTE: Also check intermediate connector C-06. If intermediate connectors C-06 is damaged, repair or replace the connector as described in Harness
Connector Inspection.
Q: Is the wiring harness between windshield wiper motor connector A-03 (terminal 2) and front-ECU connector A-11X (terminal 23) in good condition?
YES: Replace the front-ECU. The windshield wiper should stop at the predetermined park position.
NO: Repair the wiring harness. The windshield wiper should stop at the predetermined park position.
Inspection Procedure G-5
Windshield Wiper and Washer: Windshield Intermittent Wiper Interval can not be Adjusted by Means of Windshield Intermittent Wiper
Interval Adjusting Knob.
NOTE: This troubleshooting requires use of scan tool MB991958 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor." See: Reading and Clearing Diagnostic Trouble Codes/How To Use SWS Monitor
