Eclipse L4-2.4L SOHC (2004)
is damaged, repair or replace the connector as described in Harness connector Inspection.
Q: Is the wiring harness between rear combination light (LH) connector F-17 (terminal 2) and front-ECU connector A-10X (terminal 8) in good
condition?
YES: Replace the rear combination light socket assembly (LH). Check that the tail light (LH) illuminates normally.
NO: Repair the wiring harness. Check that the tail light (LH) illuminates normally.
STEP 30. Check the stop/tail light bulb (RH).
1. Remove the stop/tail light bulb (RH).
2. Check that the stop/tail light bulb (RH) is not broken.
Q: Is the stop/tail light bulb (RH) in good condition?
YES: Go to Step 31.
NO: Replace the stop/tail light bulb (RH). Check that the tail light (RH) illuminates normally.
STEP 31. Measure at rear combination light (RH) connector F-09 in order to check the ground circuit to the rear combination light (RH).
1. Disconnect rear combination light (RH) connector F-09, and measure at the wiring harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
