mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2262 > < Initial Inspection and Diagnostic Overview|Page 2260
Page 538
background image

STEP 3. Check the liftgate lock key cylinder switch connector F-10 <ECLIPSE> or the trunk lid lock key cylinder switch connector F-10
<ECLIPSE SPYDER> for damage.

Q: Is the liftgate lock key cylinder switch connector F-10 <ECLIPSE> or the trunk lid lock key cylinder switch connector F-10 <ECLIPSE SPYDER> in
good condition?

YES: Go to Step 4.

NO: Repair or replace it. Refer to Harness Connector Inspection. When the theft-alarm system operates normally, check that the signal is input
normally from the liftgate lock key cylinder switch <ECLIPSE> or the trunk lid lock key cylinder switch <ECLIPSE SPYDER>.

STEP 4. Check the harness wire between the liftgate lock key cylinder switch connector F-10 (terminal 2) <ECLIPSE> or the trunk lid lock key
cylinder switch connector F-10 (terminal 2) <ECLIPSE SPYDER> and ground.

Initial Inspection and Diagnostic Overview|Page 2262 > < Initial Inspection and Diagnostic Overview|Page 2260