Eclipse L4-2.4L SOHC (2004)
STEP 1. Check sunroof motor assembly connector D-06 by backprobing in order to the fusible link (5) line of the power supply circuit to the
sunroof motor assembly.
1. Measure at sunroof motor assembly connector D-06 without disconnecting it.
2. Measure the voltage between terminal 1 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 4.
NO: Go to Step 2.
STEP 2. Check sunroof motor assembly connector D-06 for damage.
Q: Is sunroof motor assembly connector D-06 in good condition?
YES: Go to Step 3.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The system should communicate with the sunroof motor assembly
(sunroof-ECU) normally.
