Eclipse L4-2.4L SOHC (2004)
Q: Is the stop/tail light bulb (LH) in good condition?
YES: Go to Step 25.
NO: Replace the stop/tail light bulb (LH). Check that the tail light (LH) illuminates normally.
STEP 25. Measure at rear combination light (LH) connector F-17 in order to check the ground circuit to the rear combination light (LH).
1. Disconnect rear combination light (LH) connector F-17, and measure at the wiring harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 28.
NO: Go to Step 26.
