Eclipse L4-2.4L SOHC (2004)
STEP 3. Measure at fog light (LH) connector A-28 in order to check the ground circuit to the fog light (LH).
1. Disconnect fog light (LH) connector A-28, and measure at the wiring harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check fog light (LH) connector A-28 for damage.
Q: Is fog light (LH) connector A-28 in good condition?
YES: Go to Step 5.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the fog lights illuminate normally.
