Eclipse L4-2.4L SOHC (2004)
and vanity mirror light> and ETACS-ECU connector C-119 (terminal 5).
NOTE: Also check junction block connector C-102. If junction block connector C-102 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between dome light connector D-04 (terminal 2) <ECLIPSE-vehicles without sunroof>, D-03 (terminal 6) <ECLIPSE-vehicles
with sunroof, without vanity mirror light and ECLIPSE SPYDER> or D-25 (terminal 6) <ECLIPSE-vehicles with sunroof and vanity mirror light> and
ETACS-ECU connector C-119 in good condition?
YES: Replace the ETACS-ECU. Check that the dome light illuminates normally.
NO: Repair the wiring harness. Check that the dome light illuminates normally.
STEP 11. Check the luggage compartment light bulb.
Q: Is the luggage compartment light bulb in good condition?
YES: Go to Step 12.
NO: Replace the bulb. Check that the luggage compartment lights illuminate normally.
STEP 12. Measure at luggage compartment light connector F-21 in order to check the ETACS-ECU line of the power supply to the luggage
compartment light.
1. Disconnect luggage compartment light connector F-21, and measure at the wiring harness side.
2. Measure the voltage between terminal 1 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 15.
NO: Go to Step 13.
