Eclipse L4-2.4L SOHC (2004)
2. Measure the resistance value between terminal 4 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 5.
NO: Go to Step 3.
STEP 3. Check key reminder switch connector C-88 for damage.
Q: Is key reminder switch connector C-88 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the functions, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the key reminder switch should be normal.
STEP 4. Check the wiring harness between key reminder switch connector C-88 (terminal 4) and ground.
Q: Is the wiring harness between key reminder switch connector C-88 (terminal 4) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the key
reminder switch should be normal.
