Eclipse L4-2.4L SOHC (2004)
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check driver's door lock key cylinder switch connector E-14 for damage.
Q: Is driver's door lock key cylinder switch connector E-14 in good condition?
YES: Go to Step 5.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the systems, which are described in "CIRCUIT OPERATION", work
normally, the input signal from the driver's door lock key cylinder switch should be normal.
