Eclipse L4-2.4L SOHC (2004)
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 8.
STEP 6. Check immobilizer-ECU connector C-79 for damage.
Q: Is immobilizer-ECU connector C-79 in good condition?
YES: Go to Step 7.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Confirm that scan tool MB991958 communicates normally.
STEP 7. Check the wiring harness between immobilizer-ECU connector C-79 (terminal 3) and ground.
Q: Is the wiring harness between immobilizer-ECU connector C-79 (terminal 3) and ground damaged?
YES: Repair the wiring harness. Confirm that scan tool MB991958 communicates normally.
NO: There is no action to be taken.
