Eclipse L4-2.4L SOHC (2004)
Use special tool MB990787 to fix the hub and remove the driveshaft nut.
<<C>> TIE ROD END/LOWER ARM ASSEMBLY DISCONNECTION
CAUTION:
^
Do not remove the nut from ball joint. Loosen it and use special tool MB991897 to avoid possible damage to ball joint threads.
^
Hang special tool MB991897 with rope or wire to prevent them from falling.
1. Install the special tool MB991897 as shown in the figure.
2. Turn the bolt and knob as necessary to make the jaws of special tool MB991897 parallel, tighten the bolt by hand and confirm that the jaws are
still parallel.
NOTE: When adjusting the jaws in parallel, make sure the knob is in the position shown in the figure.
3. Tighten the bolt with a wrench to disconnect the tie rod end.
INSTALLATION SERVICE POINT
>>A<< DRIVE SHAFT NUT INSTALLATION
CAUTION: Do not apply pressure to wheel bearing by the vehicle weight to avoid possible damage before securely tightening the driveshaft nut.
1. Face the flat side of a washer to a driveshaft nut to install.
2. Use special tool MB990767 to fix the hub and tighten the driveshaft nut.
