Eclipse L4-2.4L SOHC (2004)
3. Turn off the ignition switch, and then remove window motor from the body-side harness connector.
4. Align the power window motor drive shaft and the square hole in the drum by the following procedure, while using the guide and the opening
in the motor housing as a reference for the installation position.
a. Align the square hole with the drive shaft by sliding the glass bracket (glass mounting section) or by turning the drum using a ratchet
wrench [with a socket diameter of 12.7 mm (0.50 inches)].
b. Turn the drum to position the glass bracket as shown in the illustration. Support the drum and the guide with your hand while turning the
drum, otherwise the wires may pull out of the drum.
c. If the wires pull out of the drum, re-insert them by following the drum and regulator wire installation procedure.
5. Align the guide and the opening of the motor housing, and slide the guide into the motor housing while holding the guide and drum.
CAUTION: Make sure that the metal cover is installed securely and does not move, in order to stop the drum from vibrating. If the drum
vibrates, the glass may not slide up and down smoothly, or it may fall down.
