Eclipse V6-3.0L SOHC (2003)
STEP 3. Check the wiring harness between multi-center display connector C-09 and ground.
NOTE: After checking joint connector C-78, check the wires. If joint connector C-78 is damaged, repair or replace the wiring harness. Refer to Harness
Connector Inspection.
Q: Is the wiring harness between multi-center display connector C-09 and ground in good condition?
YES: There is no action to be taken.
NO: Repair the wiring harness. The multi-center display should work normally.
STEP 4. Check the multi-center display power supply circuit (battery) at the multi-center display connector C-09 by backprobing.
1. Do not disconnect the multi-center display connector C-09 and measure at the harness side.
2. Measure the voltage between terminal 1 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
