Eclipse V6-3.0L SOHC (2003)
1. Do not disconnect the multi-center display connector C-09 and measure at the harness side by backprobing.
2. Turn the ignition switch to "ON" position,
3. Measure the voltage between terminal 2 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Replace the multi-center display. The multi-center display should work normally.
NO: Go to Step 11.
STEP 11. Check the multi-center display connector C-09 for damage.
Q: Is multi-center display connector C-09 in good condition?
YES: Go to Step 12.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The multi-center display should work normally.
