Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance between Compass-ECU connector C-37 and multi-center display connector C-09.
Q: Is the resistance value less than two Ohm?
YES: Go to Step 5.
NO: Repair the wiring harness.
STEP 5. Replace the compass sensor.
1. Replace the compass sensor.
2. The system should communicate with the compass is normally.
Q: Is the compass displayed correctly?
YES: No action to be taken.
NO: Replace the Compass-ECU.
Inspection Procedure 3
The Compass Is Not Correct.
STEP 1. Check the vehicle location
Q: Are there any constructions, such as high-voltage wires or a steel bridge, which might affect the compass sensor?
YES: After moving to a location where the magnetic field is stable, check the faulty condition again.
NO: Go to Step 2.
STEP 2. Correct magnetization
Q: Was magnetization corrected?
YES: Go to Step 3.
NO: Correct magnetization.
STEP 3. Correct magnetic declination
Q: Was magnetic declination corrected?
YES: Go to Step 4.
NO: Correct the magnetic declination.
STEP 4. Demagnetize
