Eclipse V6-3.0L SOHC (2003)
16.
Place the lift link pin into the groove of the link shoe. Be sure that the collar remains on the link pin and is in the groove in the link shoe slot.
17.
Mount the link shoe on the lower (outside) pin of the link bracket, with the flange side facing inward.
18.
Mount the check block to the front (inside) shoe. Place the check block pin into the hole of the front shoe, with the check block fin facing up.
19.
Place the inside pin of the lift guide (located at the front edge of the middle shoe) into the end of the check block groove in the guide rail.
20.
Install the drive cable assembly into the guide rail as follows:
