Eclipse V6-3.0L SOHC (2003)
Technical Service Bulletin # 03-42A-005
Date: 031201
Body - Sunroof Judder/Vibration
No.: TSB-03-42A-005
DATE: December, 2003
MODEL: 2000-04 Eclipse
SUBJECT:
SUNROOF JUDDER
This bulletin supercedes TSB-01-42A-005, issued June 2001, to include 2002-04 models and provide new sunroof cable assembly part numbers, which
have improved nylon drive rail sliders. Revised information is indicated by arrow and triangle symbol.
PURPOSE
On some affected vehicles, the sunroof may judder or vibrate during opening/closing operation. In some cases, it may be necessary to replace the drive
cable assemblies. This bulletin describes how to install the new, improved drive cable assemblies (listed in the PARTS INFORMATION section of this
bulletin). Refer to MMSA Service Video # 82, CD-R 2000-42A-002 for these procedures, except be sure to clean the sunroof rails and apply sunroof
grease before installing the drive cables.
AFFECTED VEHICLES
--> 2000-2004 Eclipse models equipped with sunroof
PARTS INFORMATION
Use the new, improved Genuine Mitsubishi Parts listed.
WARRANTY INFORMATION
Procedure
1.
If the sunroof cannot be closed completely, reset the timing as follows:
a.
With the sunroof open, press and hold the switch closed. If the sunroof stops, press the switch again and continue to hold it.
b.
When the sunroof reaches the closed position, continue to hold the switch closed for 15 to 30 seconds. This will reset the timing of the
sunroof motor controller and drive cables.
c.
Confirm proper sunroof operation by opening and closing the sunroof.
2.
If the sunroof judders or vibrates during opening or closing, remove the headliner from the vehicle. Refer to Group 52A in the Eclipse service
manual.
CAUTION
THE SUNROOF MUST BE COMPLETELY CLOSED AT THIS TIME.
3.
Open the sunroof sunshade. With the sunroof in the completely closed position, remove the four Phillips or Torx screws securing the glass to the
