Eclipse V6-3.0L SOHC (2003)
STEP 7. Check the multi-center display power supply circuit [ignition switch (ACC)] at the multi-center display connector C-09 by
backprobing.
1. Do not disconnect the multi-center display connector C-09 and measure at the harness side.
2. Turn the ignition switch to "ACC" position.
3. Measure the voltage between terminal 3 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 10.
NO: Go to Step 8.
STEP 8. Check multi-center display connector C-09 for damage.
Q: Is multi-center display connector C-09 in good condition?
YES: Go to Step 9.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The multi-center display should work normally.