Eclipse V6-3.0L SOHC (2003)
STEP 9. Check the wiring harness between C-09 and ignition switch (ACC).
NOTE: After checking joint connector C-78 and junction block connector C-108 and C-111, check the wires. If joint connector C-78 and junction block
connector C-108 and C-111 are damaged, repair or replace the wiring harness. Refer to Harness Connector Inspection.
Q: Is the wiring harness between C-09 and ignition switch (ACC) in good condition?
YES: There is no action to be taken.
NO: Repair the wiring harness. The multi-center display should work normally.
STEP 10. Check the multi-center display power supply circuit [ignition switch (IG1)] at the multi-center display connector C-09 by
backprobing.
