Eclipse V6-3.0L SOHC (2003)
When the ignition switch is turned from the "ON" position to "LOCK" (OFF) or "ACC" position, the power windows can be operated for 30 seconds. If
driver's or front passenger's door is opened for the 30 seconds, the power windows will be immobilized at that point.
KEYLESS ENTRY SYSTEM
Keyless Entry Answerback Function
If the RKE transmitter "LOCK" or "UNLOCK" switch is pressed while the ignition key is removed, the doors can be locked or unlocked. If the doors are
closed, the hazard warning lights, the dome light and the horn will operate due to answerback function. Because of the answerback function, the hazard
warning lights flash twice, and the horn sounds once, the dome light flashes twice when the doors are locked. Meanwhile, when the doors are unlocked,
the hazard warning lights flash once and the dome light illuminates for 30 seconds. The hazard and the horn answerback functions can be cancelled by
using the RKE transmitter.
Trunk Lid Opener Function
After "TRUNK" switch of the transmitter is turned "ON" twice within five seconds without ignition key in the key hole, ETACS-ECU makes trunk lid
opener actuator open the trunk lid.
SUNROOF
Sunroof Operation
-
All of the slide open/close, tilt up/down, and stop operations can be performed by a single switch.
-
When the roof lid glass is tilted up, the sunshade opens approximately 98 mm (3.9 inches) in combined operation with the roof lid glass for better
ventilation.
-
A jam preventing mechanism has been adopted. When a slide-close or tilt-down operation is blocked by an external force, the roof lid glass moves
back and stops.
-
The electronic sunroof system cannot be operated manually. The sunroof wrench that was used in previous models is not provided. If the anti-jam
mechanism reverses the sunroof five or more times consecutively due to deformation or other problem with the sunroof components, it deactivates
and allows the sunroof to make small movements [30 mm (1.2 inches)] until it closes completely.
Sunroof Timer Function
When the ignition switch is turned from "ON" position to "LOCK" (OFF) or "ACC" position, the sunroof can be operated for thirty seconds. If any
door is opened for the 30 seconds, the sunroof will be immobilized at that point.
WINDSHIELD WIPERS AND WASHERS
Windshield Low-speed (and High-speed) Wiper Operation
-
If the windshield low-speed wiper switch is turned to the ON position with the ignition switch at the "ACC" or "ON" position, the column switch
sends a low-speed wiper ON and high-speed wiper OFF signals to the front-ECU. This turns the wiper signal on and the wiper speed switching
relay off (low-speed), causing the wipers to operate at low-speed.
-
If the windshield high-speed wiper switch is turned to the ON position, the column switch sends a low-speed wiper OFF and high-speed wiper ON
signals to the front-ECU. This turns both the wiper signal and the wiper speed switching relay on (high-speed), causing the wipers to operate at
high-speed.
Windshield Intermittent Wiper Operation
The ETACS-ECU calculates the wiper operation interval according to the voltage signal sent from the column switch. Then the ETACS-ECU sends a
signal to the front-ECU. The front-ECU determines the wiper operation interval and turns on the wiper relay signal relay. This causes the wiper auto stop
relay to turn on. Then the wiper auto stop relay will turn off after the wipers reach the park position. This causes the wiper signal relay and then the
wipers to turn off. If the wiper signal relay remains off for the wiper operation interval, the relay turns on again, causing the wipers to operate in
intermittent mode.
Windshield Mist Wiper Operation
-
If the windshield mist wiper switch is turned to the ON position with the ignition switch at the "ACC" or "ON" position, the mist wiper high-speed
operation signal is sent to the front-ECU. This signal turns on the wiper speed switching relay, causing the wipers to work at high-speed while the
mist switch is on.
-
While the windshield mist wiper switch remains turned on when the intermittent mode is still working, the wipers work as the mist wiper.
However, the wipers return to the intermittent mode again when the switch is changed back to "INT" position.
-
To prevent the windshield mist wiper from operating when the windshield wiper switch is turned OFF, the windshield mist wiper does not work
for 0.5 seconds after the windshield intermittent wiper switch, the windshield low-speed wiper switch and the windshield high-speed wiper switch
are turned OFF.
Windshield Washer Operation
-
If the windshield washer switch is turned to ON position with the ignition switch at "ACC" or "ON" position, the windshield washer ON signal is
sent to the front-ECU, causing the windshield wiper signal to turn on after 0.3 seconds. After the windshield washer switch signal turns off, the
