Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 56, 3 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 6.
NO: Go to Step 4.
STEP 4. Check ETACS-ECU connector C-118 and C-119 for damage.
Q: Is ETACS-ECU connector C-118 and C-119 in good condition?
YES: Go to Step 5.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The system should communicate with the SWS monitor normally.