Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 4 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 9.
NO: Go to Step 7.
STEP 7. Check column switch connector C-86 for damage.
Q: Is column switch connector C-86 in good condition?
YES: Go to Step 8.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The system should communicate with the column switch (column-ECU)
normally.
