Eclipse V6-3.0L SOHC (2003)
1. Measure at sunroof motor assembly connector D-06 without disconnecting it.
2. Measure the voltage between terminal 3 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
STEP 5. Check sunroof motor assembly connector D-06 for damage.
Q: Is sunroof motor assembly connector D-06 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The system should communicate with the sunroof motor assembly
(sunroof-ECU) normally.