Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 13.
NO: Go to Step 11.
STEP 11. Check sunroof motor assembly connector D-06 for damage.
Q: Is sunroof motor assembly connector D-06 in good condition?
YES: Go to Step 12.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The system should communicate with the sunroof motor assembly
(sunroof-ECU) normally.
STEP 12. Check the wiring harness between sunroof motor connector D-06 (terminal 5) and ground.
Q: Is the wiring harness between sunroof motor assembly connector D-06 (terminal 5) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. The system should communicate with the sunroof motor assembly (sunroof-ECU) normally.