Eclipse V6-3.0L SOHC (2003)
1. Disconnect power window relay connector C-116, and measure at the junction block side.
2. Measure the voltage between terminal 5 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
STEP 5. Check power window relay connector C-116 for damage.
Q: Is power window relay connector C-116 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the power windows work normally.