Eclipse V6-3.0L SOHC (2003)
STEP 9. Check the wiring harness between power window relay connector C-116 (terminal 3) and ground.
NOTE: Also check junction block connector C-108. If junction block connector C-108 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between power window relay connector C-116 (terminal 3) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the power windows work normally.
STEP 10. Check at power window main switch connector E-12 in order to check the power window main switch ground circuit.
1. Disconnect power window main switch connector E-12, and measure at the harness side.
2. Measure the resistance value between terminal 9 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?