Eclipse V6-3.0L SOHC (2003)
STEP 5. Check at front power window sub-switch connector E-05 in order to check the power window relay circuit of the power supply to the
power window sub-switch.
1. Disconnect power window sub-switch connector E-05, and measure at the harness side.
2. Measure the voltage between terminal 7 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 8.
NO: Go to Step 6.
STEP 6. Check power window relay connector C-116 and front power window sub-switch connector E-05 for damage.
Q: Are power window relay connector C-116 and power window sub-switch connector E-05 in good condition?
