Eclipse V6-3.0L SOHC (2003)
NOTE: Also check junction block connector C-111 and intermediate connector C-95. If junction block connector C-111 or intermediate connectors
C-95 is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between power window relay connector C-116 (terminal 4) and power window sub switch connector E-05 (terminal 7) in good
condition?
YES: No action to be taken.
NO: Repair the wiring harness. When the power window sub-switch is operated, the power window (RH) should open or close normally.
STEP 8. Measure at power window sub switch connector E-05 in order to check the ground circuit to the power window sub switch.
1. Disconnect power window sub-switch connector E-05, and measure at the harness side.
2. Measure the resistance value between terminal 8 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 11.
NO: Go to Step 9.