Eclipse V6-3.0L SOHC (2003)
1. Disconnect power window sub-switch connector E-05, and measure at the harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 14.
NO: Go to Step 12.
STEP 12. Check power window main switch connector E-12 and front power window sub-switch (RH) connector E-05 for damage.
Q: Are power window main switch connector E-12 and power window sub-switch connector E-05 in good condition?
YES: Go to Step 13.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. When the power window sub-switch is operated, the power window
