Eclipse V6-3.0L SOHC (2003)
STEP 9. Check the harness wires between sunroof motor assembly connector D-06 (terminal 2) and ignition switch (IG2).
NOTE: After checking junction block connectors C-102 and C-111, check the wires. If junction block connectors C-102 or C-111 are damaged, repair
or replace the connectors. Refer to Harness Connector Inspection.
Q: Are the harness wires between sunroof motor assembly connector C-06 (terminal 2) and ignition switch (IG2) in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the sunroof work normally.
STEP 10. Check the sunroof motor assembly ground circuit at the sunroof motor assembly connector D-06.
1. Disconnect the sunroof motor assembly connector D-06 and measure at the harness side.
