Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance between terminal 4 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 17.
NO: Go to Step 15.
STEP 15. Check the sunroof switch connector D-05 for damage.
Q: Is sunroof switch connector D-05 in good condition?
YES: Go to Step 16.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. The sunroof should work normally.
STEP 16. Check the harness wire between sunroof switch connector D-05 (terminal 4) and ground.
Q: Is the harness wire between sunroof switch connector D-05 (terminal 4) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the sunroof work normally.
