Eclipse V6-3.0L SOHC (2003)
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
STEP 5. Check windshield wiper motor connector A-03 for damage.
Q: Is windshield wiper motor connector A-03 in good condition?
YES: Go to Step 6.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the windshield wiper works normally.
STEP 6. Check the wiring harness between windshield wiper motor connector A-03 (terminal 5) and ground.
Q: Is the wiring harness between windshield wiper motor connector A-03 (terminal 5) and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the windshield wiper works normally.
STEP 7. Measure at front-ECU connector A-11X in order to check the ignition switch (IG2) line of power supply system to the front-ECU.