mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2207 > < Initial Inspection and Diagnostic Overview|Page 2205
Page 143
background image

1. Disconnect front-ECU connector A-11X, and measure at the relay box side.
2. Turn the ignition switch to the "ON" position.

3. Measure the voltage between terminal 30 and ground.

-

The measured value should be approximately 12 volts (battery positive voltage).

Q: Does the measured voltage correspond with this range?

YES: Replace the front-ECU. Check that the windshield wiper works normally.

NO: Go to Step 8.

Initial Inspection and Diagnostic Overview|Page 2207 > < Initial Inspection and Diagnostic Overview|Page 2205