Eclipse V6-3.0L SOHC (2003)
STEP 9. Check the wiring harness between front-ECU connector A-11X (terminal 30) and the ignition switch (IG2).
NOTE: Also check intermediate connector C-89, junction block connectors C-111 and C-112. If intermediate connectors C-89 or junction block
connector C-111 or C-112 is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between front-ECU connector A-11X (terminal 30) and the ignition switch (IG2) in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. Check that the windshield wiper works normally.
Inspection Procedure G-2
Windshield Wiper And Washer: The Windshield Wipers Do Not Work When The Windshield Wiper Switch Is At "INT" Or "MIST" Position
Or The Windshield Washer Switch Is At "ON" Position. However, The Wipers Work At Low Speed When The Windshield Wiper Switch Is At
"LO" Or "HI."
NOTE: This troubleshooting requires use of scan tool MB991502 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor."
TECHNICAL DESCRIPTION (COMMENT)